The short version of adsorption fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-02-21. Anything still debated is marked as such rather than presented as settled.
Cold storage slows most degradation but does not stop it. Reconstituted solutions are commonly divided into aliquots and held at -20 °C or -80 °C, depending on the peptide. Repeated freeze-thaw cycles can promote aggregation or precipitation, so single-use aliquots are preferred. Some peptides tolerate refrigeration for short intervals, while others require freezing immediately. Light-sensitive residues may need amber or foil-wrapped containers. The optimal condition remains peptide-specific and should be supported by stability data.
Analytical checks can detect changes in a reconstituted stock over time. Reverse-phase high-performance liquid chromatography can show loss of main peak, new impurity peaks, or altered retention. Mass spectrometry confirms molecular identity and can reveal modifications. Visual inspection for particles, color change, or turbidity provides a simple first check. If a solution shows signs of degradation or contamination, it is typically discarded rather than re-purified in a routine laboratory.
Once a peptide is in liquid form, its stability depends on temperature, pH, concentration, and the presence of oxygen or microbes. Refrigeration slows many degradation pathways, while freezing can extend storage for longer periods. Repeated freeze-thaw cycles are generally avoided because ice crystal formation and concentration changes can promote aggregation. Light exposure can also damage peptides that contain aromatic or sulfur-containing residues. A common laboratory practice is to divide a reconstituted stock into single-use aliquots before freezing, but the optimal storage condition remains peptide-specific and is often determined empirically.
Analytical checks help determine whether a reconstituted peptide matches its expected identity and purity; reverse-phase high-performance liquid chromatography separates components by hydrophobicity and can reveal degradation products or impurities. Mass spectrometry provides a mass measurement that supports sequence identity when compared with the theoretical value. Ultraviolet absorbance at 280 nm can estimate concentration for peptides containing tryptophan or tyrosine, though sequence-dependent extinction coefficients are needed. For shorter or non-aromatic peptides, other methods such as amino acid analysis may be required. These techniques describe the material rather than guarantee its biological effect.
| Property | Value | Notes |
|---|---|---|
| Storage temperature (reconstituted) | -20 °C to -80 °C | Exact condition depends on peptide, solvent, and stability data |
| Freeze-thaw stability | Limited number of cycles | Repeated cycles can increase aggregation and precipitation |
| Common degradation pathways | Hydrolysis, oxidation, deamidation | Relative rates depend on sequence, pH, and buffer |
| Container material | Low-binding polypropylene | Reduces adsorption loss for some peptides |
| Analytical method for stability | Reverse-phase HPLC | Monitors main peak loss and formation of impurity peaks |
After a peptide solution is prepared, its handling conditions influence how long it remains suitable for use. Solutions are typically separated into small portions to avoid repeated freeze-thaw cycles, which can promote aggregation or precipitation. Containers are chosen to minimize adsorption, especially for peptides that are hydrophobic or present at low concentration. Some laboratories use low-binding plastic tubes or add a carrier protein, although carrier addition can interfere with later analysis. Records usually note the solvent, date, and storage temperature for traceability.
Storage stability of a reconstituted peptide depends on concentration, pH, buffer composition, and the presence of oxygen or microbial contaminants. Short-term storage is often at refrigerated temperatures, while longer-term storage may use freezing at -20 °C or -80 °C. Repeated warming and cooling can cause losses through adsorption or aggregation, so aliquots are preferred. Light-sensitive peptides require protection from ambient light. Sterile filtration may be used when microbial control is needed, but filters can adsorb peptides and reduce recovery.
Quality control after reconstitution usually includes visual inspection and instrumental analysis. A clear, particle-free solution is generally expected, but color and clarity can vary with sequence and buffer. Chromatographic separation can detect degradation products, while mass confirmation verifies molecular identity. pH measurement and osmolality checks may be relevant for certain applications. Documentation of lot number, solvent, and storage history supports reproducibility and helps distinguish preparation artifacts from sample degradation. Temperature logs and freeze-thaw counts add further context when results are reviewed.
Storage conditions for reconstituted peptides are product-specific. Cool temperatures slow many degradation pathways, but freezing can concentrate solutes and promote aggregation. Light exposure can oxidize susceptible residues such as methionine, cysteine, or tryptophan. Oxygen in headspace can contribute to oxidation, while acidic or basic pH can drive hydrolysis and deamidation. The best storage condition for a given sequence is often determined empirically because general rules do not capture all sequence-specific effects.
Quality control of reconstituted peptides combines visual inspection with instrumental analysis. A clear solution does not prove correct identity or purity, and a cloudy solution does not always indicate failure. Reverse-phase high-performance liquid chromatography can separate the peptide from related impurities, while mass spectrometry confirms molecular mass and detects modifications. pH measurement and osmolality checks provide additional information about the solution environment, and documentation of lot number, solvent, and storage history supports traceability.
A number of AlphaFold clones have also been published, mostly with permissive license terms. Clones for AlphaFold3 include ByteDance's Protenix (Apache 2.0 License), AlQuraishi Laboratory's OpenFold-3 (MIT license), and Boltz-1/2 (MIT license). There are also clones for older versions, though they became less relevant with the open-source release of AlphaFold 1 and 2 source codes. Still relevant are models, both open- and closed-source, that include modifications to the AlphaFold architecture. For AlphaFold 2, a notable example is ESMFold from Meta, which replaces the multiple sequence alignment with the latent space of a protein language model. Open-source tools that complement AlphaFold have also been made. One well-cited example is ColabFold, which uses MMseqs2 instead of HHblits to speed up the sequence search, allowing the AlphaFold pipelines to run quickly on Google Colab.
Acid–base extraction is a subclass of liquid–liquid extractions and involves the separation of chemical species from other acidic or basic compounds. It is typically performed during the work-up step following a chemical synthesis to purify crude compounds and results in the product being largely free of acidic or basic impurities. A separatory funnel is commonly used to perform an acid-base extraction. Acid-base extraction utilizes the difference in solubility of a compound in its acid or base form to induce separation. Typically, the desired compound is changed into its charged acid or base form, causing it to become soluble in aqueous solution and thus be extracted from the non-aqueous (organic) layer. Acid-base extraction is a simple alternative to more complex methods like chromatography. It is not possible to separate chemically similar acids or bases using this simple method.
Polycondensation involves the formation of polymers through condensation reactions between different species, creating condensation polymers. With automated synthesis, General electric manufactured an approach for melt-polymerizations of BPA and diphenyl carbonate (DPC), using sodium hydroxide (NaOH) as the catalyst. Once the results were analyzed, it was shown that, by using an automated method of polymerization, the effect of varying the catalyst amount became more distinct and improved the reproducibility for the reaction. Furthermore, it demonstrated an increase within the homogeneity of the polymers in the microreactors.
Sources: en.wikipedia.org
Scleroderma, polymyositis, and dermatomyositis elicit little or no CRP response. CRP levels also tend to remain low despite inflammatory activity in systemic lupus erythematosus (SLE) unless serositis or synovitis is present. This may be explained by increased levels of type I IFN in SLE, since type I IFN (i.e IFN alpha) inhibits hepatic CRP production. A polymorphisms of the CRP gene which cause lower CRP levels is also more frequent in SLE patients compared with controls. Elevations of CRP in the absence of clinically significant inflammation can occur in kidney failure. CRP level is an independent risk factor for atherosclerotic disease. Patients with high CRP concentrations are more likely to develop stroke, myocardial infarction, and severe peripheral vascular disease. Elevated level of CRP can also be observed in inflammatory bowel disease (IBD), including Crohn's disease and ulcerative colitis. High levels of CRP has been associated to point mutation Cys130Arg in the APOE gene, coding for apolipoprotein E, establishing a link between lipid values and inflammatory markers modulation.
Benninghoven graduated from the University of Cologne in 1961 where he worked with Fritz Kirchner (1896–1967) and completed his habilitation in surface physics in Cologne two years later. He first worked as professor in Cologne from 1965 to 1973 until he moved to a full professor position in experimental physics at the University of Münster in 1972. He worked on static secondary ion mass spectrometry (SIMS) and its applications, and developed SIMS instruments. In 1989 he co-founded IonTOF, a company that became a world-leader in TOF-SIMS instrumentation. He has written over 300 scientific articles and several books on the topic of SIMS, many of which have become reference works on SIMS. For his work, he has received the Technology Transfer prize (German Ministry of Education and Research) and the 1984 Gaede-Langmuir Prize (American Vacuum Society) for the development of concepts and instrumentation in static secondary ion mass spectrometry and the demonstration of its usefulness in manifold applications. In 1990 he shared the Fritz-Pregl-Medaille of the Austrian Society of Analytical Chemistry with Wilhelm Simon. From 1977 to 1983, he was president of the German Vacuum Society (part of the German Physical Society).
These drugs have been derived from NSAIDs. The cyclooxygenase enzyme inhibited by NSAIDs was discovered to have at least two different versions: COX-1 and COX-2. Research suggested most of the adverse effects of NSAdiated by blocking the COX-1 (constitutive) enzyme, with the analgesic effects being mediated by the COX-2 (inducible) enzyme. Thus, the COX-2 inhibitors were developed to inhibit only the COX-2 enzyme (traditional NSAIDs block both versions in general). These drugs (e.g., rofecoxib, celecoxib, and etoricoxib) are equally effective analgesics when compared with NSAIDs, but cause less gastrointestinal hemorrhage in particular. After widespread adoption of the COX-2 inhibitors, it was discovered that most of the drugs in this class increase the risk of cardiovascular events by 40% on average. This led to the withdrawal of rofecoxib and valdecoxib, and warnings on others. Etoricoxib seems relatively safe, with the risk of thrombotic events similar to that of non-coxib NSAID diclofenac.
Sources: en.wikipedia.org
All CHO cell lines are deficient in proline synthesis. Also, CHO cells do not express the epidermal growth factor receptor (EGFR), which makes them ideal in the investigation of various EGFR mutations. Furthermore, Chinese hamster ovary cells are able to produce proteins with complex glycosylations, post-translational modifications (PTMs) similar to those produced in humans. They are easily growable in large-scale cultures and have great viability, which is why they are ideal for GMP protein production. Also, CHO cells are tolerant to variations in parameters, be it oxygen levels, pH-value, temperature or cell density. Having a very low chromosome number (2n=22) for a mammal, the Chinese hamster is also a good model for radiation cytogenetics and tissue culture. Being the first cell line to be used for recombinant pharmaceutical production, regulatory concerns were raised with respect to Endogenous Retroviral Sequences (ERS). CHO cells contain about 1000 of these sequences and some of them are able to direct the synthesis of Intracisternal A-type particles and C-type particles. Also, low expression of reverse transcriptase was observed. However the majority of ERS are defective (stop codons in all reading frames) and contain large deletions of a putative retroviral genome.
While genome annotation is primarily based on sequence similarity (and thus homology), other properties of sequences can be used to predict the function of genes. In fact, most gene function prediction methods focus on protein sequences as they are more informative and more feature-rich. For instance, the distribution of hydrophobic amino acids predicts transmembrane segments in proteins. However, protein function prediction can also use external information such as gene (or protein) expression data, protein structure, or protein–protein interactions. Evolutionary biology is the study of the origin and descent of species, as well as their change over time. Informatics has assisted evolutionary biologists by enabling researchers to:
All the proteolytic activity of the asparagine peptide lyases is only self-cleavages, then no further peptidase activity occurs. The main residue of the active site is the asparagine and there are other residues involved in the catalytic mechanism, which are different between the different families of asparagine peptide lyases. The cleavage mechanism consists in the cyclization of the asparagine, assisted by other active site residues. In certain conditions, the asparagine cyclic structure nucleophilically attacks its C-terminal peptide bond to the main chain forming a new bond to create a stable succinimide, cleaving itself from the main chain and consequently releasing the two halves of the product. No inhibitors are known.
As of 2019, AAV vectors have been used in over 250 clinical trials worldwide, approximately 8.3% of virus-vectored gene-therapy trials. Recently, promising results have been obtained from Phase 1 and Phase 2 trials for a number of diseases, including Leber's congenital amaurosis, hemophilia, congestive heart failure, spinal muscular atrophy, lipoprotein lipase deficiency, and Parkinson's disease. AAV based gene therapy products have entered the worldwide market following completion of successful clinical trials. The table below contains FDA approved gene therapies that have entered the American Market and possibly other markets.
Sources: en.wikipedia.org
No single time applies to all peptides. Storage life depends on sequence, solvent, concentration, and temperature. Stability should be determined experimentally or taken from supplier data for the specific lot.
Refreezing is possible but repeated cycles are discouraged. Each freeze-thaw step may increase aggregation or loss. Aliquoting before freezing reduces the number of cycles.
Cloudiness, visible particles, color changes, or new peaks in chromatography can indicate degradation. A loss of expected activity in an assay may also suggest a problem. Confirmatory methods include LC-MS and purity analysis.
Short-term storage is often under refrigeration, while longer storage may use freezing at -20 °C or lower. The choice depends on peptide stability and the solvent. Dividing the solution into aliquots reduces repeated temperature changes.